Planet SGSW-24040 - STP Port Mode; STP Port Edge

User’s Manual of SGSW-24040 / 24240 Series
461
1 Enabled Enabled Enabled Disabled Disabled Disabled Auto
STP Port Mode
Description:
Set or show the STP enabling for a port.
Syntax:
STP Port Mode [<port_list>] [enable|disable]
Parameters:
<port_list>: Port list or 'all'. Port zero means aggregations.
Enable : Enable MSTP protocol
Disable : Disable MSTP protocol
Default:
Enable
Example:
Disable STP function on port1
SWITCH/>stp port mode 1 disable
STP Port Edge
Description:
Set or show the STP adminEdge port parameter.
Syntax:
STP Port Edge [<port_list>] [enable|disable]
Parameters:
<port_list>: Port list or 'all', default: All ports
Enable : Configure MSTP adminEdge to Edge
Disable : Configure MSTP adminEdge to Non-edge
Default:
Enable