PMDG 737 - The Parking Brake Does Not Engage

PMDG 737 0.00.37
INTRODUCTION
For Simulator Use Only DO NOT DUPLICATE NOVEMBER 2022
The Parking Brake Does Not Engage:
To set the parking brake, you must FIRST apply full brake then set the
parking brake latch on the pedestal. The red light will illuminate, and the
latch will be locked in place.
To release the parking brake, you must apply full brake pressure. If you
are using keyboard for the brakes you need to press the brake key for 2-3
seconds.
NOTE: If you set the Neutrality slider in MSFS' sensitivity options to -45%,
the brake latch won't engage.