0.00.54 PMDG 737
INTRODUCTION
NOVEMBER 2022 DO NOT DUPLICATE For Simulator Use Only
These panel states can be loaded at any time and the airplane will be
instantly configured according to the panel state selected. This can be
convenient for quickly setting up a flight to start precisely where you want!
Save/Load Effect on Failures:
In the PMDG 737 the current state of failures is always saved. If you have
a particular failures mode saved, and various failures are already active or
armed to become active, they will remain as such when you load the flight
that was saved in that condition.
This can be useful for saving flights enroute without losing any of the
activities that have taken place earlier in the flight sequence.
Some users may not want the failure conditions to transfer to a newly
loaded flight. If this is a concern, then please be certain that you clear all
failures and disable failures from the FAILURES menu prior to saving the
flight.
Save/Load from the MSFS menu:
You can also conduct save/load operations from the MSFS menu. The
PMDG 737 will intercept the save/load function and create both the MSFS
save file and the PMDG 737 panel save file for you using the name you
select.
You will then be able to load your flight and panel state from the MSFS
menu as well and the airplane condition will be just as you left it.
On the PMDG SETUP menu you will notice a STARTUP STATE prompt.
You can use this prompt to force MSFS to load the PMDG 737 in exactly
the same configuration every time you launch the simulator.
To Next Page
Loading...