9.12
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.
16. Field test machine at low speed before putting into
service. Check for proper braking action and pedal
reserve. With pedal firmly applied, pedal reserve
should be no less than 1/2"(1.3 cm).
17. Check brake system for fluid leaks.
BRAKE BURNISHING PROCEDURE
It is required that a burnishing procedure be performed
after installation of new brake pads to extend service life
and reduce noise.
Test drive machine and slowly increase speed to above
20 mph. Gradually apply brakes to stop machine. Allow
pads and disc to cool sufficiently during the procedure.
Do not allow pads or disc to become hot or warping may
result. Repeat this procedure 10 times to maximize pad
service life.
BRAKE SYSTEM
To Next Page
Loading...
Need help?
General
