9
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.
9.33
REAR CALIPER INSTALLATION
1. Install the rear caliper onto the mounting bolts.
Torque mounting bolts to specification.
TORQUE
Rear Caliper Mounting Bolts:
46 ft-lbs (62 Nm).
2. Install brake line banjo bolt. Torque banjo bolt to
specification.
TORQUE
Banjo Bolt:
15 ft-lbs (20 Nm)
3. Install the rear wheel and wheel nuts. Carefully lower
the vehicle.
4. Field test unit for proper braking action before putting
into service. Inspect for fluid leaks and firm brakes.
Make sure the brake is not dragging when pedal is
released. If the brake drags, re-check assembly and
installation.
NOTE
If new brake pads are installed, brake burnishing is
recommended (see “REAR BRAKE PADS - Brake
Burnishing Procedure”).
BRAKE SYSTEM
To Next Page
Loading...
Need help?
General
