5.13
BODY / SUSPENSION / STEERING
5
A-arm Replacement
1. Elevate the front end of the vehicle far enough off the
ground to remove the wheel.
2. Loosen and remove the (4) wheel nuts.
3. Remove the (2) screws from the brake line retainer attached
to the front A-arm.
4. Remove the lower shock mounting bolt.
5. Remove the cotter pin, castle nut and washer from the bolt
attaching the A-arm to the spindle.
6. Carefully remove the spindle assembly from the A-arm.
7. Remove the front and rear A-arm mounting fasteners (refer
to the “Exploded View”) and remove the A-arm from the
vehicle.
8. To reinstall, reverse steps 1-7. Torque fasteners to
specification.
Severe injury could occur if machine tips or falls.
A-arm to Spindle Castle Nut: 30 ft. lbs. (41 Nm)
Front Shock Mounting Bolt: 36 ft. lbs. (49 Nm)
Wheel Nuts: 27 ft. lbs. (37 Nm)
PartShark.com
877-999-5686
To Next Page
Loading...
