5.3
BODY / SUSPENSION / STEERING
5
Seat Installation
1. Lift up the seat latch lever located under the right front
edge of the driver’s seat.
2. While holding the lever upward, line up the seat guides with
the seat mounting rails and slide the seat rearward to install
it. Adjust the seat to the appropriate distance and be sure
the seat is latched
3. To install the passenger seat, place the seat mounts into the
mounting loops on the frame support and install the front
retaining nuts.
4. Torque the front retaining nuts to specification.
Front Bumper Removal / Installation
1. Remove the (2) push rivets from each side of the front
bumper.
2. Remove the (4) screws retaining the front bumper to the
frame.
3. Disconnect the daytime running lights as shown and
remove the bumper from the vehicle.
4. Reverse this procedure to reinstall the front bumper.
Tighten all fasteners securely.
Front Cab Removal / Installation
1. Remove the (6) push rivets retaining the rear portion of the
front cab to the frame.
2. Remove the (2) push rivets from each side, retaining the
front cab to the front bumper.
Passenger Seat Retaining Nuts:
10 ft. lbs. (13.5 Nm)
Body Component Fasteners:
16 in. lbs. (1.8 Nm)
PartShark.com
877-999-5686
To Next Page
Loading...
