8.17
ELECTRICAL
8
Starter Motor Service
The starter motor is a complete service part. If it is determined
that the starter motor is the failed part, replace as needed. See the
parts manual for correct part number.
Although the starter motor is not serviceable, it can be
disassembled, tested and cleaned.
Starter Disassembly
NOTE: Use only electrical contact cleaner to clean
starter motor parts. Other solvents may leave a
residue or damage internal parts and insulation.
NOTE: Some starter motors may not be serviceable.
Replacement of entire assembly may be required.
Check the parts manual for replacement part
information.
1. Disconnect the negative battery cable and starter motor
harness. Remove the (2) bolts from the starter and pull it
from the engine.
2. Remove the three screws and washers.
3. Remove magnet housing while holding the armature and
brush holder section together.
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
