Polaris RZR 170 2009 - Crankshaft, Balance Shaft and Starter Drive Gear Installation; Chain Guide;Tensioner Installation

3.35
ENGINE
3
7. Install the two mag side flange bolts and torque to
specification.
Chain Guide/Tensioner Installation
1. Install the chain guide and tighten the mounting bolt to
specified torque.
Crankshaft, Balance Shaft and Starter Drive
Gear Installation
1. Install woodruff keys on the balancer shaft and crankshaft.
2. Install and align the marks of the balance shaft gear and the
crankshaft gear as shown.
3. Install the oil pump drive sprocket, washer and slotted nut
onto the balance shaft.
4. Using Slotted Nut Socket PA-47344, tighten the nut to the
specified torque.
= T
Crankcase Bolt Torque:
14 - 15 ft. lbs. (19-21 Nm)
Crankcase Sealant
PN 2871557
= T
Chain Guide Bolt Torque:
5-6.5 ft. lbs. (7-9 Nm)
= T
Balance Shaft Slotted Nut Torque:
43 ft. lbs. (59 Nm)
Special Tool:
PA-47344
Alignment marks
A
B
Install
PartShark.com
877-999-5686