7.12
CVT / TRANSMISSION
TRANSMISSION SERVICE
Transmission Disassembly and Inspection
IMPORTANT: To ensure proper shifting, verify shift
cables are in good condition, routed properly, and
adjusted properly after transmission is assembled
and engine is installed.
1. Remove drain plug (A) and drain oil from case.
2. Remove shift cable bracket (B) and shift arm screw (C).
3. Mark shift shaft and shift cable arm orientation before
removing the arm.
4. Remove angle drive inspection / oil fill cover.
NOTE: Angle drive removal is not required for
transmission cover removal or access to internal
transmission components. Drive pinion gear (D) and
shaft will stay with cover when removed.
5. Remove (3) angle drive output housing screws. Remove
housing.
6. Note number of shims for assembly.
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
