Installation and Operation Manual Page 64 of 104
(PVI-3.8/4.6-I-OUTD-US Rev.: 1.1)
system repaired.
G
R
5) Malfunction/Fault indication
Every time the AURORA inverter's check system detects an
operating malfunction or fault of the monitored system, the
yellow LED comes on and a message showing the type of
problem found appears on the LCD display.
G
R
6) RS-485 address setup indication
During installation, the yellow LED will keep flashing until the
address is acknowledged. For further information about the
address entry mode, refer to section 6.3.
G
R
7) Grid disconnection
If a grid failure event occurs while the system is in normal
operation, the yellow LED turns on steady and the green LED
flashes.
To Next Page
Loading...
