Precor Experience Series 800 line EFX - Page 116

3. Disconnect the Positive (Red) and Negative (Black) battery terminal cables.
4. Remove the following LPCA interface cables:
a.
Disconnect the Generator (J1) cable .
b.
Disconnect the Eddy/Brake (J7) cable .
c.
Disconnect the Lift (J3) cable .
d.
Disconnect the Battery (J9) cable .
e.
Disconnect the Comm Serial (J2) cable .
f.
Disconnect the Active Status Light (J12) cable .
Experience Series 800 Line EFX
109
5 Replacement Procedures
LPCA (Lower PCA) Board Replacement