EasyManuals Logo

Precor Experience Series 800 line EFX User Manual

Precor Experience Series 800 line EFX
181 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
The Information Display menu provides information about the machine usage, software, main-
tenance, and the error event code log.
P10, P20, and P30 consoles
METRIC DESCRIPTION
ODOMETER The total number of accumulated miles on the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
HOUR METER The total number of hours that the unit took to accumulate
unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
BELT RATING
(2)
Displays the belt rating from 10 (best) to 0 (worst). Reset-
table to 10 by holding down QuickStart.
MAINT COUNTER Hours remaining until maintenance is required (initializes
to 250 hrs, approximately 1 month use).
Press/Hold the PAUSE/RESET key to reset the counter.
U-BOOT SW The console Upper Boot software version information.
U-BASE SW The console Upper Base software version information.
METRICS BOARD SW The console Metrics board software version information
L-MAJOR SW The LPCA Major processor software version information.
L-MINOR SW The LPCA Minor processor software version information.
Note: The Minor software versions can only be viewed
while the user is pedaling. If the user isNOT pedaling, then
the software will be displayed as “--------------“.
L-ASL SW The LPCA Active Status Light processor software version
information.
SER NUMBER Displays the model and serial number of the machine. The
base serial number can be set using the WinCSAFE com-
puter software. The factory default is NONE.
USAGE LOG Displays the type of workout programs the users are
accessing most frequently.
"Error Log & Event Log" on
page131
Table of stored error event codes.
TIP: You can quickly access the Error log by holding down
the PAUSE key. Will show the STUCK KEY message
when there are no logged error codes.
(1) Only available on ASL equipped models.
(2) TRM800-14, TRM700-16 models
P62, P80, and P82 consoles
Experience Series 800 Line EFX
29
3 Standard Service and Diagnostics Menus
Information Display (65)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Precor Experience Series 800 line EFX and is the answer not in the manual?

Precor Experience Series 800 line EFX Specifications

General IconGeneral
BrandPrecor
ModelExperience Series 800 line EFX
CategoryElliptical Trainer
LanguageEnglish

Related product manuals