Precor Experience Series 800 line EFX User Manual

Viewing Logged Error Codes
Error event codes are logged, stored, and viewed in either the Error Log or Event Log depend-
ing on the console model, see .Error Log & Event Log
P10, P20, and P30: access Information Display (6,5) > select Error Log.
TIP: Deleting Error Codes from the Error Log: Press and hold the PAUSE/RESET
key for a minimum of 6 seconds to open the Error Log and view all logged error codes.
If there are no logged error codes, the "Stuck Key" message will show. To remove
error codes, select the error code and press/hold the QUICK START key until the
"NO ERRORS" message shows.
P62, P80, and P82: Access Hardware Validation (5,1,7,6,5,7,6,1) > select About > CPA
1
Event Log
Note: Unlike the Error Log, error codes cannot be manually removed from the CPA
Event Log.
1
Control Processing Assembly
Experience Series 800 Line EFX
126
6 Troubleshooting
Standard Error Codes

Precor Experience Series 800 line EFX Specifications

General

Brand	Precor
Model	Experience Series 800 line EFX
Category	Elliptical Trainer
Language	English