Precor Experience Series 800 line EFX User Manual

Installation Instructions
1.
If removed, reinstall the AC Adapter (J4) cable .
2. Reinstall the LPCA board using the two #2 Phillips screw fasteners.
3. Reconnect the following LPCA interface cables:
a.
Reconnect the Lift (J3) cable .
b.
Reconnect the Battery (J9) cable .
c.
Reconnect the Comm Serial (J2) cable .
d.
Reconnect the Active Status Light (J12) cable .
e.
Reconnect the Generator (J1) cable .
f.
Reconnect the Eddy/Brake (J7) cable .
4. Reconnect the Positive (Red) and Negative (Black) battery terminal cables.
5. Reinstall the LPCA/Battery module cover using the one #2 Phillips screw fastener.
6. Reinstall the Left Drive Disk cover, see "Drive Disk Covers Replacement" on page57.
7. VVerify machine operation and return to service, see "Operation Verification" on
page11.
Experience Series 800 Line EFX
111
5 Replacement Procedures
LPCA (Lower PCA) Board Replacement

Precor Experience Series 800 line EFX Specifications

General

Brand	Precor
Model	Experience Series 800 line EFX
Category	Elliptical Trainer
Language	English