Precor Experience Series 800 line EFX User Manual

3. Disconnect the negative battery cable (black terminal) and then the positive battery
cable (red terminal).
4. If installed, cut the zip tie.
5. Remove the battery.
Installation Instructions
1. Reconnect the positive cable to the positive terminal (red) and then the negative battery
cable to the negative terminal.(black).
2. Reinstall the battery.
3. Make sure the positive wire remains securely connected thru the inline fuse to the LPCA
board.
4. Make sure the negative wire remains securely connected to the frame weldment.
5. Reinstall the LPCA/Battery module cover using the one #2 Phillips screw fastener.
6. Reinstall the left drive disk cover, see "Drive Disk Covers Replacement" on page57.
7. Verify machine operation and return to service, see "Operation Verification" on page11.
Experience Series 800 Line EFX
46
5 Replacement Procedures
Battery Replacement

Precor Experience Series 800 line EFX Specifications

General

Brand	Precor
Model	Experience Series 800 line EFX
Category	Elliptical Trainer
Language	English