Precor Experience Series 800 line EFX User Manual

6. Use a 1/2" socket to loosen second stage belt tension and walk the second stage drive
belt off the pulleys. Remove the second stage drive belt.
Installation Instructions
1. Install the second stage drive belt by walking the belt onto the Drive Components
Assembly second stage pulleys. Rotate the crank and make sure that the belt is prop-
erly aligned and seated on both pulley grooves. Adjust the second stage tensioner
enough to hold the tensioner and belt in place.
2. Install the first stage drive belt by walking the belt onto the input drive and first stage
drive pulleys. Rotate the crank and make sure that the belt is properly aligned and
seated in the pulley grooves. Adjust the first stage tensioner enough to hold the ten-
sioner and belt in place.
Experience Series 800 Line EFX
74
5 Replacement Procedures
Second Stage Drive Belt Replacement

Precor Experience Series 800 line EFX Specifications

General

Brand	Precor
Model	Experience Series 800 line EFX
Category	Elliptical Trainer
Language	English