S3.55 Assembly and Maintenance Guide
page 10
1 2 3 4 5 6
3. Attach the Side Rails
Note: Perform the following steps on one side
at a time.
A. Position one Side Rail next to the Main Frame so
that the three holes are at the top.
B. Attach the Side Rail to the Upper Cross Brace
using
one 2-inch bolt (blue patch)
one washer
Finger tighten.
C. Attach the base of the Side Rail to the Main Frame
using
one 2½-inch bolt
two washers
1 locknut
Finger tighten.
D. Repeat steps A through C to attach the opposite
Side Rail.
Step 3. Attach the Side Rails
1 - 2" bolt
1 - washer
B
Side Rails
Upper Cross
Brace
1 - 2½" bolt
2 - washers
1 - locknut
C
Main Frame
1 - 2" bolt
1 - washer
D
D
1 - 2½" bolt
2 - washers
1 - locknut
To Next Page
Loading...
