Precor S3.55 User Manual

S3.55 Assembly and Maintenance Guide
page 54
1 2 3 4 5 6
4
Adjustments and
Maintenance
Adjustments and Maintenance
This section provides information on how to tension the
cables due to incorrect installation, misalignments, or
cable stretching. Obvious signs that Cable problems
exist include:
✔ The Top Cap Weight does not rest squarely on the
top weight of Weight Stack.
✔ A gap exists between the base of a double or single
pulley dock and the cross piece that it rests on.
✔ The Cable rubs the inside edges of the pulleys.
✔ Excess slack exists in the Cables.
Note: All cables stretch. If you use the equipment often
and consistently select a higher weight resistance, the
cables lengthen, which causes slack.
Important: To make cable adjustments, use a hex key
to remove the eight bolts and washers that secure the
Rear Shroud. Set the fasteners and shroud aside.
Rear Shroud
Remove 8 fasteners. Set fasteners and
shroud aside.
Proper alignment of Pulley Docks.

Precor S3.55 Specifications

Weight and Dimensions

length	86 inch (218 cm)
width	68 inch (173 cm)
height	82 inch (203 cm)
shipping weight	812 lb (370 kg)