96
9 Master Control
9.6 Scenes and Projects
StudioLive™ Series III
Owner’s Manual
9.6.6 Reset
For both Projects and Scenes, you’ll find a Reset button. This button resets the
currently loaded Project or Scene to the default state. Because you will potentially
lose any changes to your current mix, you will be prompted to confirm this choice.
Project Reset
Inputs and Buses Mode
Input Channels n/a
FlexMix Mode Aux (All FlexMixes)
FlexMix Pre/Post Pre 1 (All FlexMixes)
FX Mix Pre/Post Post
Solo Settings
AFL
Radio Solo Mode
Solo Level: Unity
Phones Cue Source Solo
Peak Hold Off
Sample Rate 48 kHz
Link Aux Mute Mode Unlinked
Network IP Mode Dynamic
Transport Controls SD Card
GEQ No Assignments
Note: See Section 14.2 for the default Digital Patching menu routing for every mixer
model.
Scene Reset
Inputs and Buses Output Level Assign Pan Solo Mute Stereo Link Aux/FX Sends Type
Input Channels
(All Mixes)
-∞ Mains C Off Off Off -∞ n/a
FX (All) Unity Mains n/a n/a Off n/a n/a
Digital XL
Reverb
Aux In A/B -∞ Mains n/a n/a n/a n/a -∞ n/a
Tape In -∞ n/a n/a n/a n/a n/a -∞ -∞
The Fat Channel will be restored to the same setting for every input and output on
the StudioLive. Each of the dynamics processors and all EQ bands will be turned off.
To Next Page
Loading...
