Printronix LP654C - Checking;Changing the State of this Machine

- 206 -
 If you forget the admin password, you cannot change [Admin Setup] or [Boot Menu]. Or, if you wish to reset the
password, the charged service by maintenance staff will be necessary.
1 Open the web page of this machine.
Opening the web page
2 Log in as an administrator.
Logging in as an administrator
3 Select [Admin Setup].
4 Select [Management] - [Admin Password].
5 Input the new password in [New Admin Password].
6 Input the new password again in [New Admin Password(Verify)].
The password you input is not displayed. Write down your password and keep it in a safe place.
7 Click [Submit].
It is not necessary to restart the machine. The next time you log in as an administrator, use the new password.
Checking/Changing the state of this machine
 Set the security level of your browser to medium or enable Cookies.
 The admin password is required to enter [Admin Setup].
Changing admin password (Web page)
 To change settings of this machine from the web page, it is necessary to log in as an administrator.
Logging in as an administrator
 About network setup
Connecting via a wireless LAN
Connecting via a wired LAN
This section takes the following environment for example.
 Device name: LP654C
 IP address of this machine: 192.168.0.2
Checking the state of this machine
1 Open the web page of this machine.
Opening the web page
2 Log in as an administrator.
Logging in as an administrator