Sets whether to save restricted print data.
When [Private Print only] is selected, print data other than private print
will not be accepted.
Selects whether to verify the job password when the access control is
enabled.
Selects whether to perform job search at the same time as unlocking
the panel when the access control is enabled.
Management
Sets the information about this machine.
Sets the information about USB.
Sets the access control function.
Sets various types of actions of this machine in correspondence to
various situations such as unit of measurement and alarm release.
Sets power save, sleep and auto power off.
Sets the items to be displayed on the screen.
Adjusts the volume when an error occurs, when the printing has
completed, when AirPrint is checked, and when the IC card is held up (if
the IC card reader is installed).
Used to initialize the flash memory and format a partition.
Sets whether to save the job log. Also used to clear saved job logs.
Sets the actions when «CANCEL» is pressed.
Language
Maintenance
Setup
Sets the language for the screen display, the web page display and the
report printing.
Sets the information about the font output mode.
Paper Feed Roller Counter Clear
Clears the counter after the paper feed roller is replaced.
Save the data set in "Setting", and initialize the recalling.
Transmits settings of this machine which are saved and filed to the PC.
File and save the settings of this machine to a PC.
Enables or disables the counter of maintenance parts.
Sets the configurations checked over the network.
Sets the information about SNTP.
Sets the notification timing for the replacement of the image drum, fuser
and belt unit.
To Next Page