---
NFC Unit Error. NFC Function Is
Not Available
Press OK To Hide This Message
An error has occurred to the NFC unit.
NFC-specific functions are not available.
Power off/on this machine.
You can hide this message by selecting [Disable] for [Admin
Setup] - [Others Setup] - [NFC Setup].
---
Incompatible USB Device
Connected
Please Detach It
A USB device that is not supported by this machine is
connected.
Please detach the USB device.
---
Fuser Unit Near Life. Search
Keyword: P10979
The fuser unit is approaching the end of its service life.
Prepare a new fuser.
After the message of replacement is displayed, please replace
it with a new one.
---
Change Fuser Unit. Search
Keyword: P40971
The fuser unit has reached the end of its service life.
Please replace the fuser unit with a new one. To replace the
fuser unit, see "Replacing the fuser unit ".
---
Waste Toner Near Full. Search
Keyword: P10949
The free space of the waste toner box is low.
Please prepare a new waste toner box.
After the message of replacement is displayed, please replace
it with a new one.
---
Change Waste Toner Box. Search
Keyword: P40942
The waste toner box is full. Please replace the waster toner
box with a new one.
For the method, see "Replacing the black(K) toner cartridge
and the waste toner box ".
---
Collate Fail:Too Many Pages
Press OK To Hide This Message
The memory is full with the collation data.
Reduce the number of pages of the print data.
---
Invalid Print Data Received
Press OK To Hide This Message
If you were printing a private job, the data was deleted because
it was not complete.
Please print it again.
Or, the received PLD command data is not supported.
Please check the printer driver in use.
---
Duplex Print Failed
Press OK To Hide This Message
Printed on one side because the paper setting is not applicable
to duplex printing.
To print on both sides, print again from the tray with paper
suitable for duplex printing. For paper settings applicable to
duplex printing, see "Applicable paper ".
---
Wait Timeout Is Disabled
Timeout Injob is set to [Off].
When the USB cable is connected, you may not be able to print
from the network.
Please Wait
Executing Maintenance
Please Do Not Power Off
Firmware update is in progress.
If the power is turned off halfway, this machine may not be able
to start.
When update is completed, the machine restarts automatically.
To Next Page
Loading...
