Printronix LP654C - Page 378

- 379 -
Symptom
Cause
Solution
Reference
The machine is not
restored even after the
jammed paper is
removed.
-
Open and close the front cover.
-
The paper gets curled.
The paper is waved.
The paper is wrinkled.
The paper is moist or
charged with static
electricity.
Use the paper stored at appropriate
temperature and humidity.
Storing paper
Thin paper is used.
Press the scroll buttons on the operator panel
to select [Menus] - [Tray Configuration] - [(Tray
Name) Config] - [Media Weight]. Then, change
the current setting to a thinner value.
Setting paper
information on
the operator
panel
The paper gets curled.
The paper is waved.
Thin paper is used.
Press the scroll buttons on the operator panel
to select [Menus] - [Print Adjust] - [High Humid
Mode], and change the setting.
-
The paper twines
around the inside of
the fuser.
The media weight is
set incorrectly.
Press the scroll buttons on the operator panel
to set an appropriate value in [Menus] - [Tray
Configuration] - [(Tray Name) Config] - [Media
Weight].
Or, change [Media Weight] to a thicker value
than the present one.
Setting paper
information on
the operator
panel
Thin paper is used.
Use thicker paper.
-
There is near-solid
filling at the top edge
of the paper.
Try leaving a margin at the top edge of the
paper.
With duplex printing, try leaving a margin at the
rear edge of the paper.
-
The paper winds
around the belt unit.
Thin or soft paper is
used.
Use thicker paper.
For A5 size, change the orientation of the
paper.
-
Corners of the paper
are folded (the edge is
folded).
The paper is curled.
The paper is waved.
Use the paper stored at appropriate
temperature and humidity.
Storing paper
The envelope is
wrinkled.
The paper is moist.
Use the paper stored at appropriate
temperature and humidity.
Storing paper
This machine is being
used in high
temperature and
humidity.
Press the scroll buttons on the operator panel
to select a mode (Mode1, Mode2 or Off) from
[Menus] - [Print Adjust] - [High Humid Mode].
Menu list
If the problem persists
Load the envelope with the flap facing the main
unit. Next, from Print Setup, set the orientation
to 180° reversion.
Screens and
functions of the
printer driver
Misalignment occurs
when paper is output
from the expansion
tray.
Misalignment occurs
with each tray.
Press the scroll buttons on the operator panel
to select the tray to adjust in [Menus] - [Print
Adjust] - [Print Position Adjust], and correct the
value of [X Adjust] (Landscape) or [Y Adjust]
(Portrait).
Correcting the
print position of
the tray
The edge of the paper
is wet.
Wet paper is used.
Press the scroll buttons on the operator panel
to select [Menus] - [Print Adjust] - [Moisture
Control], and change the setting.
-
The paper is
automatically fed from
another paper tray
Tray Switch is set to
Auto.
Change the Auto Tray Switch setting in the
printer driver.
Screens and
functions of the
printer driver