Printronix S828 - Page 175

ProgrammerManual PTX‐S828
Chapter5IPDSProgrammingInformation 173 260071‐001A
The Data bytes contain immediate data that specifies values for the attributes in this instruction. If the
Default byte is 0F, these Data bytes are not present.
The Set byte specifies one of the following attributes or parameters:
Set Value Description
00 Drawing Attributes
01 Line Attributes
02 Character Attributes
03 Marker Attributes
04 Pattern Attributes
0B Arc Parameters
The following charts explain the meaning of the mask bits for each of the Set instructions. Refer to the
drawing order descriptions for supported attribute values.
Drawing Attributes Set (Set = 00):
Mask Bit Item Name Length (Bytes)
0 Color 2
1-15 Reserved (Mask Bits = 0) -
Line Attributes Set (Set = 01):
Mask Bit Item Name Length (Bytes)
0 Line Type 1
1 Line Width 1
2-15 Reserved (Mask Bits = 0) –
Character Attributes Set (Set = 02):
Mask Bit Item Name Length (Bytes)
0 Angle X, Y 4
1 Cell size CW, CH 4
2 Direction 1
3 Precision 1
4 Symbol Set 1
5 Shear X, Y 4
6-15 Reserved (Mask Bits = 0) –