Printronix S828 - Page 229

ProgrammerManual PTX‐S828
Chapter6IPDSExceptionReportingCodes 227 260071‐001A
X'029101' BO Overlay Number Already Loaded
Explanation: The host attempted to download an
overlay from the Begin Overlay command that
already exists in the printer.
Alternate Exception Action: None.
X'029102' Invalid Request Resource List
Parameter
Explanation:
1. The Requested Ordering parameter of a
Request Resource List order is not a valid or
supported value.
2. The Entry Index parameter of a Request
Resource List order is not a valid or supported
value.
3. The Resource Qualifier parameter of a
Request Resource List order is not a valid or
supported value.
4. The Resource Type parameter on the
Request Resource List order is not a valid or
supported value.
Alternate Exception Action: None.
X'029201' Overlay Number Not Loaded
Explanation: The overlay identified by the Overlay
Identifier on the Include Overlay, Deactivate Overlay
or LCC command was not loaded or was already
deleted prior to its attempted use.
Alternate Exception Action: None.
X'029202' Invalid Print Quality Control
Parameter:
Explanation: The Print Quality Control
parameter is X'00', which is a reserved value.
Alternate Exception Action: None.
X'029301' Recursive Overlay Invocation:
Explanation: An infinite nesting loop has occurred
with the Include Overlay command (for example, an
overlay has included itself).
Alternate Exception Action: None.
X'029401' Recursive Overlay Invocation:
Explanation:
1. The Page Segment Identifier on the Include
Page Segment command is not a valid or
supported value.
2. The Page Segment Identifier on the Begin
Page Segment command is not a valid or
supported value.
Alternate Exception Action: None.
X'029501' Page Segment Number Already
Loaded
Explanation: The host attempted to download a
page segment that already exists in the printer.
Alternate Exception Action: None.
X'029601' Page Segment Number Not
Loaded
Explanation: The page segment identified by
the Page Segment Identifier on the Include
Page Segment or Deactivate Page Segment
command was not loaded or was already
deleted prior to its attempted use.
Alternate Exception Action: None.
X'029701' Overlay Nesting Limit Exceeded
Explanation: Depth of overlay nesting is greater
than the maximum depth.
Alternate Exception Action: None.
X'029801' Suppression Number Outside
Valid Range
Explanation:
1. On a Write Text command, the Begin
Suppression number value is not a valid or
supported value.
2. In a LCC command, the suppression number
value is not a valid or supported value.
Alternate Exception Action:
1. Ignore the control sequence.
2. None.


