Printronix S828 - Page 398

ProgrammerManual PTX‐S828
AppendixIConfigurationMenuLockout 396 260071‐001A
Intelligent Mail Bar Code 4-state with Native Commands Mode
(Native Bar Code Mode)
DC4 DC4 ESC ! h “ f EM
UPPS Bar Code Selection.
ASCII Code DC4 DC4 ESC ! h “ f F r EM
Hexadecimal Value X'14' X'14' X'1B' X'21' h X’22’ f F r X’19’
Decimal Value 20 20 27 33 h 34 f F r 25
h = Bar Code Height at n/6”, 1 < h < 30
f = Readable character printing
f = 0 printing disabled
f = 1 printing enabled, characters below barcode, justified position
f = 21 printing enabled, characters above barcode, justified position
f = 81 printing enabled, characters below barcode, middle position
f = A1 printing enabled, characters above barcode, middle position
F = Font selection for the printable characters
0 Selected font by r value
1 Default font for text
1 Special font for OCR-A o OCR-B bar codes according to the t value
3 Special font for OCR-A bar codes
4 Special font for OCR-B bar codes
r = Bar code rotation
r Selection
0 No rotation
1 Rotation at 0°
2 Rotation at 90°
3 Rotation at 180°
4 Rotation at 270°
EM = Check sequence terminator