Printronix S828 - Page 399

ProgrammerManual PTX‐S828
AppendixIConfigurationMenuLockout 397 260071‐001A
Intelligent Mail Bar Code 4-state with Epson/IBM Emulations Commands
(Alt. 1 Bar Code Mode)
See chapter 1, pages 54, 55 for details of these commands.
Remark: these commands are not handled in DEC emulations.
ESC [ v n m
Sets Barcode parameters. (IBM -Epson)
ASCII Code ESC [ vnm
Hexadecimal Value X'1B' X'5B' X'76' nm
Decimal Value 27 91 118 nm
Set barcode parameters according to the table below. Parameter values that are not supported result in
the command being ignored.
n Parameter Description m values
0 Barcode style IMB 4-state X ‘22’, 34 dec
2 Human readable line 0=disable
1, 21 =enable below barcode
81, A1 =enable above barcode
8 Rotation and HRC font 0.1=no rotation and current font for HRC
2=90 3=180 4=270 and special HRC font
11 HRC font for rotate barcode 3=OCRA 4=OCRB
Intelligent Mail Bar Code 4-state with MTPL Commands
(Native Bar Code Mode)
ESC [ 9 SP k CR
Sets bar code parameters (BC).
ASCII Code ESC [ 9 SP k CR
Hexadecimal Value X'1B' X'5B' X’39’ X'20' X’6B’ X’0D’
Decimal Value 27 91 57 32 109 13
In next pages a specific sub-chapter describes the MTPL (Mannesmann-Tally Printer Language) commands
which can be handled by S828 printer.