Printronix S828 - Page 56

ProgrammerManual PTX‐S828
Chapter1EPSON/IBMCommands  54 260071‐001A
ESC[ u n
Bar Codes selection. (IBM -Epson)
ASCII Code ESC [ u n
Hexadecimal Value X'1B' X'5B' X'75' n
Decimal Value 27 91 117 n
This command is recognized only if the Bar Code menu option is set to “Alternate” mode.
n
0 Exit Bar Code mode
1 Enter Bar Code mode. Subsequent data are barcode data strings as set by ESC [ v n
ESC [ v n m
Sets Barcode parameters. (IBM -Epson)
ASCII Code ESC [ vnm
Hexadecimal Value X'1B' X'5B' X'76' nm
Decimal Value 27 91 118 nm
Set barcode parameters according to the table below. Parameter values that are not supported result in
the command being ignored.
n Parameter Description m values m default
0 Barcode style see below table 4
1 Barcode height 1-120 (1/12" increments) 12
2 Human readable line 0=disable 1=enable 1
3 Narrow bar width 2-225 3
4 Wide bar width 2-225 7
5 Narrow space width 2-225 3
6 Wide space width 2-225 7
7 Intercharacter space width 2-225 3
8 Rotation and HRC font 0.1=no rotation and current font for HRC 0
2=90 3=180 4=270 and special HRC font
9 Horizontal print density 1=120 2=144 3=180 dpi 1
10 Check digit 0=disable 1=enable 0
11 HRC font for rotate barcode 3=OCRA 4=OCRB 3
12 Barcode height 0-240 (1/24" increments) 24
Supported Bar Code Styles
m Style
0 Interleaved 2 of 5
1 Bidirectional 2 of 5
2 Matrix 2 of 5
3 Industrial 2 of 5