Device Manual CANlink wireless
Safety information
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0 18
© 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016 PROEMION GMBH > 1.0 EN > Device Manual CANlink wireless 3000 series
CAUTION
Health hazards of radio-frequency energy
Slight or medium injury.
During operation, observe a distance of at least 20 cm between the antennas and
personnel.
NOTICE
Interference with electronic equipment caused by radio-frequency energy.
Observe all special regulations and cut power supply to the CANlink wireless when its
use is prohibited or you are not sure whether operation could cause interference or
danger.
NOTICE
Property damage.
The device must be installed, connected, and commissioned by a qualified technician.
Disconnect the device completely before handling it.
Also disconnect any independently supplied output load circuits.
Provide all the device connectors with plugs and any protection caps required to ensure
protection class IP67 (model variant 3001) or IP65 (model variant 3002).
Never immerse the device in water or other liquids.
The device must only be repaired by the manufacturer.
Do not operate the device without antennas.
Keep substances that contain solvents away from the type label.
To Next Page
Loading...
