PROEMION CANlink wireless 3002 - 4.6.2 Performing a function test of the CAN-CAN-WLAN Bridge

Device Manual CANlink wireless
Getting started
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0 86
© 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016 PROEMION GMBH > 1.0 EN > Device Manual CANlink wireless 3000 series
4.6.2 Performing a function test of the CAN-CAN-WLAN Bridge
It is advisable to perform a function test before using the device. In order to do so, you can
simulate the CAN bus with the aid of two communication gateways (e.g. CANview USB) and
read it out with RM CAN-Device Monitor software.
The function test procedure is the same as that for the CAN-CAN-Bluetooth Bridge. See chapter
Performing a function test of the CAN-CAN-Bluetooth Bridge.