RLX2 Industrial Hotspot Series
ProSoft Technology, Inc. Page 113 of 212
June 15, 2015
Note: Clients often support more than one WEP key. Packets received can be decrypted using any
one of the keys if programmed, but packets are always transmitted with the "default" WEP key
number. If a transmit key number is set on the RLX2 radio, make sure all other radios and clients
have this key programmed. To set keys other than key 1 on some clients using Windows,
Advanced settings may be used.
Programming more than one key on the RLX2 radio requires setting the key number to
the key, entering the key, and saving the changes. Repeat these steps for each key to
program, saving after each one. Finally, change to the desired transmit key number if
necessary and save again (If "****" remains in the key field, the previously programmed
key will not be changed when changes are applied)
To Next Page
Loading...
Need help?
General
