RLX2 Industrial Hotspot Series
ProSoft Technology, Inc. Page 115 of 212
June 15, 2015
Radio Access Settings
Note: Different versions of the RLX2 radios support different functionality. You may see
more or fewer options on this page, depending on the version of the radio you
purchased.
In order to configure or diagnose a radio using its built-in Web server or SNMP agent,
both your computer and radio must have IP addresses, and these IP addresses must be
on the same sub-network. An IP address is only needed so you can figure the radio and
view its diagnostic settings. Otherwise, the address is unnecessary.
The following fields appear in the Security Settings area on the right side of the Radio
Configuration window.
Allows the radio to obtain its IP address from a DHCP server.
Use the following IP address
Specifies a Static IP address to the radio. Enter the IP address information in
the following fields.
Use an IP address that will not interfere with any other devices on the
network. Request a block of IP addresses to use from the Network
Administrator.
To Next Page
Loading...
Need help?
General
