RLX2 Industrial Hotspot Series
ProSoft Technology, Inc. Page 61 of 212
June 15, 2015
Check the Ethernet Cable
If the radio’s Ethernet port is connected and the Ethernet LED does not light on the
radio, there may be a problem with the Ethernet cable. Verify the cable is plugged into
the radio at one end, and to an Ethernet hub or a 10/100/1000 Base-T Ethernet switch
at the other end.
If using the PoE injector, verify that the M12 to RJ45 cable is connected between the
radio and the injector and also that the Ethernet patch cable is connected between the
injector and switch.
Note: The RLX2 radio auto-detects the Ethernet connection type, and does not require a crossover
cable for direct connection to a PC.
To Next Page
Loading...
Need help?
General
