RLX2 Industrial Hotspot Series
Page 48 of 212 ProSoft Technology, Inc.
June 15, 2015
Consider drawing up the network plans on paper. As part of the drawing, assign a
logical name to each radio. These names can be assigned in the Radio Configuration
/ Diagnostic Utility.
As part of the planning, a site survey may be helpful. You can hire ProSoft
Technology or a surveyor to perform a survey, or you can conduct the survey on
your own.
Protect radios from direct exposure to weather, and provide an adequate, stable
power source. Make sure the plan complies with the radio’s power requirements
and cable specifications.
Important: Radios and antennas must be located at least 8 inches (20 cm) away from personnel.
To Next Page
Loading...
Need help?
General
