PTW MP3-PL - Mounting the Inhomogeneous Phantom T43031; Mounting the Hemisphere T41029.3.231; Figure 23: Mounting the Inhomogeneous Phantom T43031; Figure 24: Mounting the Hemisphere T41029.3.231

MP3-PL Therapy Beam Analyzer T41050
Operating Manual – Installation of the System for Measurement
D850.131.05/01 en
39
3.5 Mounting the Inhomo-
geneous Phantom T43031
Figure 23: Mounting the inhomogeneous phantom
T43031
1 Screw M6x16 (4x)
2 Inhomogeneous phantom T43031 with holder
T41029.1.240
3 Perspex tank
 Mount the inhomogeneous phantom T43031 on
the holder T41029.1.240 according to the inho-
mogeneous phantom user manual.
 Mount the holder with the inhomogeneous phan-
tom (2) on the outside of the Perspex tank (3) in
front of the entrance window using the four
M6x16 screws (1).
3.6 Mounting the Hemisphere
T41029.3.231
Figure 24: Mounting the hemisphere T41029.3.231
1 Screw M6x16 (4x)
2 Holder T41029.1.230
3 Hemisphere T41029.3.231
4 Screw M6x12 (4x)
5 Perspex tank
 Remove the hemisphere T41029.3.231 from the
inhomogeneous phantom T43031 according to
the inhomogeneous phantom user manual.
 Mount the hemisphere (3) on the holder
T41029.1.230 (2) using the four M6x12
screws (4).
 Mount the holder (2) with the hemisphere (3) on
the outside of the Perspex tank (5) in front of the
entrance window using the four M6x16
screws (1).
3
2
1
3
2
1
5
4