QubicaAMF 400288005 - Software Setup for Dual Mode; Dual Mode Conqueror X Lane Setup

How to BES X installation manual
116 P/N: 400288005; Rev: L, 09/21
14.6 How to clean a SuperTouch or an EasyKey console
• Exercise care when cleaning the surfaces as the exteriors of a console can be easily scratched.
• Take the following steps when cleaning.
• The following images are for reference only. Real-life situations may differ from what is shown in the
images.
1 - Power off the pair of lanes by disconnecting the power cord from the 4HD/5HD-HUB or by turning off
the breaker.
• When disconnecting the power cord from the socket: hold the power cable by the plug and do not
touch the cable with wet hands. Otherwise, an electric shock may result.
• Unless specifically instructed, avoid using any of the following chemicals or products containing
these chemicals as they will cause permanent damage to some console surfaces:
o Any chlorine-based cleaner such as bleach;
o Peroxides (including hydrogen peroxide);
o Solvents such as Acetone, paint thinner, Benzene, Methylene Chloride or Toluene;
o Ammonia-based products (like many glass cleaners);
o Ethyl Alcohol.
2 - Wipe the surface of the console or keypad with a microfiber cloth
moistened with a 70% Isopropyl Alcohol solution or use a
disinfecting wipe. The cloth should be damp, but not dripping wet.
3 - DO NOT spray water, detergent or any other liquid directly on to
the console.
4 - DO NOT allow liquids to get inside the unit as this may cause major
damages to the console and void the manufacturer warranty.
5 - Wet a soft and dry cloth in water and wring thoroughly to clean the
exterior of the console.
6 - DO NOT excessively wipe or use a material other than a microfiber
cloth. This could potentially cause damage to the console surfaces.
7 - Power on the pair of lanes when cleaning is finished.