QubicaAMF 400288005 - TMS Installation; Typical Layout with 5 HD-HUB; 5 HD-HUB Connection with Highway66 or Duckpin

BES X installation manual BES X Dual Mode
P/N: 400288005; Rev: L, 09/21 121
15.3 TMS Installation
T.90.262 – Typical layout with 5HD-HUB
T.90.263 – 5HD-HUB connection with Highway66 or Duckpin
BACKEND MOTOR
DIAG
E-STOP
MASK LED
BALLLIFT
BALL DETECTOR
HBR INPUTS
SPARE RELAYFOUL DETECTOR
BUMP RELAY
PITLIGHT
MOTOR DRIVE
INPUTS
PIN DETECTOR VDC +1 2
SPARE INPUTS
SWEEPBRAKE
TABLEBREAK
STACKLIGHT
MTR DRV SIG
PIN DETECTOR
RED LIGHT
COUNTER
PITLIGHT
MOTOR DRIVE
INPUTS
PIN DETECTOR VDC + 12
SPAREINPUTS
SWEEPBRAKE
TABLE BREAK
STACKLIGHT
MTR DRVSIG
PIN DETECTOR
RED LIGHT
COUNTER
SCORING
MCU IN MCU OUT
DMX MTR DRV RS -4 85
TMS CONTROLLER
TMS CHASSIS
5HD HUB-
POWERTo Scoring
Network switch
I/O CONTROLLER
*: Please refer to the HW66 installation manual for the
Coin Op and Bill Acceptor connection.
To 4 -HD/5HD CPU To Odd SuperTouch To Even SuperTouch
COIN OP*
BILL ACCEPTOR*
TICKET DISPENSER
P/N: EC200364
‘ ’FROM 5HD-HUB D1 CONNECTOR
CHASSIS TO SCORINGTMS ‘ ’
CONNECTOR
P/N : 200365 (HW-66) EC
P/N : (Duckpin) EC200365-01
5 -HUB ‘ ’ FROM HD CONNECTORD2
I/O ‘ ’TO YCOMCONTROLLER D4
CONNECTOR
The 5HD-HUB unit must
be installed under the
TMS chassis in the
support used for the
chassis.