BES X installation manual System boot-up sequence
P/N: 400288005; Rev: L, 09/21 105
13 System boot-up sequence
13.1 Boot-up screen description
During the boot-up of the system, the following image is displayed (note that this image is only an example
and may vary):
This is an example of the boot-up screen that is displayed on the lane monitors during the boot-up sequence
of the BES X system.
1. The boot-up process information (“system booting”, “please reinitialize the system”, etc.) is shown in
this part of the screen;
2. The serial number (S/N) of the 4HD/5HD-CPU and the IP address assigned to that unit is shown in this
square.
3. The operations performed by the system during the boot-up process are shown in this area.
4. The monitor number is shown in this area. NOTE: this is NOT the lane number, but the number for
the monitor of that pair of lanes, so the monitor on the odd lane is always 1 and the monitor on the
even lane is always 2.
To Next Page
Loading...