System components BES X installation manual
4 P/N: 400288005; Rev: L, 09/21
• N1 Network: Standard network connection to the scoring network.
4HD/5HD-HUB LEDs:
Each RJ45 port is equipped with two colored LEDs (orange and green).
• N1:
o Green: The LED is ON when a link is present.
o Orange: The LED flashes when it is transmitting or receiving data from the network.
• L1, L2, L3 and L4:
o Green: Power Over Ethernet status. When the LED is ON, it indicates the 4HD/5HD-HUB is
providing the correct power over Ethernet to the connected device.
o Orange: The LED flashes when it is transmitting or receiving data from the network.
• 4HD-HUB Rev.1 and 4HD-HUB Rev.2 D1 and D2:
o Green: Power output status. When the LED is ON, it indicates the CPU is providing the correct
power to the connected device.
o Orange: XCOM communication line. The LED flashes when the XCOM line is running.
• 5HD-HUB D1 and D2:
o Tx: The LED flashes when transmitting data from the connected device.
o Rx: The LED flashes when receiving data from the connected device.
1.1.6 How the 4HD/5HD-HUB works
The communication between the 4HD/5HD-HUB unit and the front desk is based on the TCP/IP protocol.
The operation of the 4HD/5HD-HUB is similar to a normal network hub, with the additional functionality to
give power to all the lane devices (4HD/5HD-CPU, SuperTouch, EasyKey, pinspotter interface, etc.) connected
to it. The turning on/off of the 4HD/5HD-HUB results in the turning on/off of the entire pair of lanes devices
(4HD/5HD-CPU, SuperTouch, EasyKey, pinspotter interface, etc.).
1.1.7 288250025-02 5HD-HUB specs
To Next Page
Loading...