QubicaAMF 400288005 - How to Replace the 4 HD;5 HD-CPU Unit

BES X installation manual BES X Dual Mode
P/N: 400288005; Rev: L, 09/21 125
15.4.2 How to install the card reader on the pedestal
1. (Re)Install the two (2) remaining screws. Tight the five (5) retaining screws. (Re)Install the V-Support
back, running the console cables through one of the arms of the V-Support. Take care not to pinch
any wires or cables.
2. Fix the table to the card reader plate (P/N: 286002877), using four (4) PHPTS 8 X 0.63 ZN TYA screws
(P/N: 822430100).
3. Connect the network cable to the ethernet interface of the card reader. Connect the supplied 4-pin
cable to the “EC-2003-54” cable connected to the CTRL I/O interface, following the sequence
specified in the table below. Connect the card reader of the odd lane to the cable connected to J1
and the card reader of the even lane to the cable connected to J2.
I/O CONTROLLER
J1 J2
COINS
Red
Black
White
P/N: EC-2000-54
COINS
( LANE)ODD
COINS
Red
Black
White
P/N: EC-2000-54
COINS
( LANE)EVEN
FROM THE
CARD READER
ON THE ODD LANE
FROM THE
CARD READER
ON THE EVEN LANE
+12 VDC
(Red)
GND
(Black, Green)
Credit IN
(White/Green)
Credit IN
(White/Green)
GND
(Black, Green)
+12 VDC
(Red)
4-pin cable
wire color
EC-2003-54
“Coins” cable
Signal
Red
White / Green
Red
White
+12 VDC
Credit in
Black
Green
Black
GND