QubicaAMF 400288005 - How to Replace an Easykey Console; How to Replace a Supertouch Console

Replacements BES X installation manual
128 P/N: 400288005; Rev: L, 09/21
Click OK.
Click on Yes when the Warning message appears.
Wait for Conqueror X to process the request;
NOTE: This procedure will take almost an hour to finish. DO NOT switch off the BES X system during this
process.
When the whole process is complete, a confirmation message (Lane control box replaced) will
appear. Press OK.
Refer to the par. How to upload animations to the 4HD/5HD-CPU units to correctly upload the animations
to the new 4HD/5HD-CPU.
16.3 How to replace an EasyKey console
Turn off the 4HD/5HD-HUB by unplugging the power cord from the 4HD/5HD-HUB unit to turn off the pair of
lanes where the faulty EasyKey console is installed;
Disconnect and remove the faulty EasyKey console from the pedestal;
Fix and connect the new EasyKey console in the same way as the old one;
Check that all the cables are connected;
Turn on the new 4HD/5HD-HUB.
16.4 How to replace a SuperTouch console
Turn off the 4HD/5HD-HUB by unplugging the power cord from the 4HD/5HD-HUB unit to turn off the pair of
lanes where the faulty SuperTouch console is installed;
Disconnect and remove the faulty SuperTouch console from the pedestal;
Fix and connect the new SuperTouch console in the same way as the old one;
Check that all the cables are connected;
Turn on the new 4HD/5HD-HUB.
Wait until Test LCD R Error 199 or Test LCD L Error 199 appears on the overhead monitors, or when the lane
boots-up properly.
Navigate through the Conqueror X main menu and select:
SETUP / Lane Setup / Upload to Lanes.