BES X Installation Manual, Rev.9, Jun 2018 System first start-up
P/N: 400288005 123
5. Enter the serial number of the 4HD/5HD-CPU. Set also the number of the monitors, the pinsetter
interface, the keyboards type and all other desired options (refer to the “12.2 – Lane setup
parameters screen brief description” paragraph for a brief description of each parameter); click on
the “Ok” button when finished.
6. Repeat the procedure from the step 4 for each pair of lanes installed.
7. On the LANE SETUP screen click on the “Save” button. Now ConquerorPRO will restart.
8. Now each lane will restart within five minutes.
9. Wait until the following picture appear on the lane monitors.
NOTE: Depending on which version of ConquerorPRO has been installed in the center, the picture
visualized on the lane monitors could be one between the two following pictures:
10. In ConquerorPRO go to the ConquerorPRO main menu: Setup / Technical Setup / Upload to lanes
To Next Page
Loading...