System first start-up BES X Installation Manual, Rev.9, Jun 2018
126
126 P/N: 400288005
30. Select the target lanes, enable the Reset option and press OK.
31. When the parameters have been uploaded the system will reboot.
32. In the case of SuperTouch LCD monitors have been installed, they will start to load the programs.
33. During the load programs procedure on the SuperTouch screens will be displayed an image with a
blue background. This means that the procedure is in progress. If an error occurs an image with a
red background will be displayed and the procedure will stop. If the procedure ends correctly on
the SuperTouch monitors will be displayed an image with a green background, then after a few
seconds the system will reboot.
34. Once all the lanes are up and running, upload the animations to the lanes. Please refer to the
section “12.3 – How to Upload animations to the 4HD/5HD-CPU units”.
To Next Page
Loading...