Rae ppbRAE 3000

To Next Page

To Previous Page

ppbRAE 3000 User’s Guide

Pressing [N/-] steps you from screen to screen. Options include

clearing the Peak value and turning on the instrument’s PC

Communications for data transfer to a PC.

Main Page

Table of Contents3
Read before Operating7
Special Notes8
Warnings9
Standard Contents11
General Information11
Physical Description13
Specifications13
Charging the Battery17
- Charging a Spare Rechargeable Battery18
- Low Voltage Warning19
- Clock Battery19
- Data Protection While Power Is off19
User Interface20
Display22
Operating the Instrument23
- Turning the Instrument on23
- Turning the Instrument off24
- Operating the Built-In Flashlight24
- Pump Status24
- Calibration Status25
- Bump Status25
Policy Enforcement26
Operating Modes30
Basic User Level/Hygiene Mode (Default Settings)31
Alarm Signals33
- Alarm Signal Summary34
- Preset Alarm Limits & Calibration35
- Testing the Alarm35
Integrated Sampling Pump35
Backlight36
Datalogging36
- Datalogging Event36
- Datalogging Sample36
- Auto/Manual/Snapshot Datalogging37
- Standard Kit & Accessories38
- AC Adapter38
- Alkaline Battery Adapter38
- External Filter38
Optional Accessories41
Standard Two-Point Calibration (Zero & Span)42
- Entering Calibration43
- Zero (Fresh Air) Calibration44
- Span Calibration46
- Exiting Two-Point Calibration in Basic User Level48
Three-Point Calibration49
Bump Test50
- Span 2 Calibration51
- Exiting Three-Point Calibration53
Programming Mode55
- Entering Programming Mode55
Programming Mode Menus56
- Calibration60
  - Zero Calibration60
  - Span Calibration60
- Measurement61
  - Meas. Gas61
  - Meas. Unit62
- Alarm Setting63
- Datalog68
Entering Search Mode from Hygiene Mode82
- Lamp ID83
- Pan ID83
- Mesh Channel83
- Mesh Interval83
Hygiene Mode84
Basic User Level & Hygiene Mode85
Advanced User Level (Search & Hygiene Mode)85
Advanced User Level & Hygiene Mode88
Basic User Level & Search Mode90
Advanced User Level & Search Mode92
Diagnostic Mode94
- Entering Diagnostic Mode94
- Adjusting the Pump Stall Threshold95
- Pump High95
- Pump Low95
- Exiting Diagnostic Mode95
Transferring Data to & from a Computer97
- Downloading the Datalog to a PC97
- Uploading Firmware to the Instrument from a PC98
- Maintenance99
- Battery Charging & Replacement99
- Replacing the Li-Ion Battery100
- Replacing the Alkaline Battery Adapter100
- PID Sensor & Lamp Cleaning/Replacement102
- Special Servicing Note106
Troubleshooting107
Technical Support108
RAE Systems Contacts109
Controlled Part of Manual110

Rae ppbRAE 3000 - Page 86

Table of Contents

Related product manuals