Rae ppbRAE 3000 User Manual

ppbRAE 3000 User’s Guide
85
Entering Search Mode From Hygiene Mode
In order to change the instrument’s operational mode from Hygiene
Mode to Search Mode, you must enter the password-protected
Programming Mode:
1. Hold [MODE] and [N/-] until you see the password screen.
2. Use [Y/+] to increment to the number you want for the first
digit. (If you pass by the desired number, press [Y/+] until it
cycles through to 0 again. Then press [Y/+] until you reach
the desired number.)
3. Press [N/-] to advance to the next digit.
4. Again press [Y/+] to increment the number.
5. Press [N/-] to advance to the next digit.
Continue the process until all four numbers of the password have
been input. Then press [MODE] to proceed.
The screen changes to icons with the label “Calibration.”
1. Press [N/-] to advance to “Monitor Setup.”
2. Press [Y/+] to select Monitor Setup.
Under Monitor Setup, you will see “Op Mode.”
Press [Y/+] to select.
You will see:
Hygiene
Search
The current mode is indicated by a dark circle within the circle in
front of either Hygiene or Search.
1. Select Hygiene or Search by pressing [N/-].
2. Press [Y/+] to place the instrument into the selected mode.

Rae ppbRAE 3000 Specifications

General

Brand	Rae
Model	ppbRAE 3000
Category	Measuring Instruments
Language	English