86
ESP-LXME Controller
MV Water Window
Sometimes you may want to use quick coupling valves or other manual
watering methods during times when you are not irrigating. To ensure
that these devices have water, you can set up an MV Water Window.
The MV Water Window works the same way as other Water Windows,
but instead of allowing irrigation it simply opens the Normally Closed
master valve (NCMV) and allows a user-dened ow rate to coordinate
with ow sensing if installed.
Set Up MV Water Window
Turn the controller dial to Manual Watering.
A
The Manual Watering screen appears. Press the Down Arrow
button to select MV Water Window ; then press Next.
B
The MV Water Window screen appears with MV Water Window
selected; press Next.
1 2
C
Press the + and – buttons to set the time when the MV Water
Window opens; then press Next.
Press and HOLD buttons to accelerate settings for hours and
minutes.
D
Press the + and – buttons to set the time when the MV Water
Window closes. As you adjust the end time, the duration of your
MV Water Window calculates automatically; then press Next.
NOTE: To clear a previously set MV Water Window, press the + and
– buttons to set both the Open and Close times to OFF (between
11:59 PM and 12:00 AM).
3 4
To Next Page
Loading...
Need help?
General
