EB200 Manual SENSe subsystem FREQuency
4052.2000.02 4.65 E-7
. . [CW|FIXed]? [MINimum|MAXimum]
Query of receiver frequency
Parameters:
none query of current receiver frequency
MINimum|MAXimum query of lowest|highest receiver frequency
Result:
Frequency value in Hz
Example:
FREQuency? -> 98500000
. . :DSCan
If the STARt and/or STOP frequency is changed then CENTer or SPAN is adjusted.
If CENTer of SPAN is changed, then the STARt or STOP frequency is adjusted.
Either CENTer and SPAN or STARt and STOP frequency can be changed in a command at the same
time. Other parameter combinations will be rejected.
. . . :CENTer <numeric_value>|MINimum|MAXimum
Sets the center frequency of Digiscan.
Corrects STARt and STOP frequency.
Parameter:
<numeric-value> frequency value
MINimum | MAXimum setting min/max center frequency
*RST state:
97.5 MHz
Example:
FREQuency : DSCan : CENTer 118 MHz
. . . :CENTer? [MINimum|MAXimum]
Query of the center frequency of Digiscan
Parameters:
none query of the current center frequency
MINimum | MAXimum query of the min/max center frequency
Result:
Frequency value in Hz
Example:
FREQuency : DSCan : CENTer?
→ 118000000
To Next Page
Loading...
