Rauch AERO GT 60.1 - Page 108

Check the following functions of the electronic control unit:
•
Checking the forward speed sensor
• Checking the filling level sensors
• Metering shaft speed
Check the function of the sensors and actuators with the AERO ISOBUS electronic machine
control unit.
•
Observe the operator’s manual of the AERO ISOBUS electronic machine control unit.
n
Checking the metering shaft speed
u
Check
the gap size between the magnet
and the encoder [1].
There are a total of 6 encoders on the machine.
They are always placed directly on the metering
drive.
u
In case of faults, please follow the
instructions in chapter 9 Faults and
possible causes.
Fig. 68: Right metering
n
Checking the forward speed sensor
During transport and spreading, the current driving speed is displayed on the operating screen of the
machine control unit.
u
If this is not the case, check the driving speed sensor or the calibration.
10. Maintenance and service
108
5903494 AERO GT 60.1