Component Oil volume Oil designation
On-board hydraulic system
(V
ario drive)
approx. 40 l HVI 68 (HVLP 68 DIN 51524/ 3
ISO VG-68)
Do not mix different types of oil and do not use bio-oils.
u
Prior to draining the oil, position a
sufficiently sized collection vessel (at least
45 l) under the hopper.
u
Detach the hydraulic hose [3] from the axial
piston pump and let the oil flow into the
collection vessel [4].
u
Open the oil drain plug on the oil reservoir
[1] and drain the residual oil into the
collection vessel.
u
Close the oil drain plug with a new sealing
ring.
u
Remove the oil filter [2].
u
Drain the residual oil into the collection
vessel.
u
Fill the new oil filter with approx. 2 liters of
oil.
u
Screw on the new oil filter.
u
Fasten the hydraulic hose [3] to the axial
piston pump.
The oil filter has been successfully replaced.
Fig. 78: Oil filter
10. Maintenance and service
AERO GT 60.1 5903494
117
To Next Page
Loading...
